Resin Flexible Steel Plates For Elegoo Mars/Anycubic Photon/Photon Mono/SE/ Mono X

43 reviews for Resin Flexible Steel Plates For Elegoo Mars/Anycubic Photon/Photon Mono/SE/ Mono X

1. 4 out of 5

   

   Semco – March 3, 2022

   Fairly pleased with this product. I doubt the difference between the next competitor and this one is worth the $ increase. I’ve had good adhesion to the build plate every time, magnet pad is 3M brand adhesive if that matters to anyone. I’ve noticed a fine layer of resin about 1/4” to 1/2” around the border between the magnet and the plate so it’s probably lifting a bit. I don’t usually print super close to the edges and even if you did I’m betting theres some capillary action pulling the thing in. I do recommend what someone else did, use some clamps and a board to install the thing firmly to the original build plate.

   (0) (0)
2. 4 out of 5

   

   Amazon Customer – February 22, 2022

   Much like most things in a hobby like this, it needed a fine adjustment. I just needed to sand the plate so that the prints would stick a little better. Works great.

   (0) (0)
3. 5 out of 5

   

   Chase – February 17, 2022

   Just make sure you let dry for 3 days

   (0) (0)
4. 4 out of 5

   

   J33 – February 17, 2022

   My first two prints with this were total failures sticking to the FEP. Once I sanded the magnetic build plate prints finally stuck. I suggest 220 – 400 grit sandpaper.

   (0) (0)
5. 5 out of 5

   

   Kindle Customer – February 17, 2022

   I have not experienced any flex wile printing. Stand flat threw the entire printing process.

   (0) (0)

Sorry, no reviews match your current selections